Česká verze| Display notice | Reason and retraction. |
|---|---|
| Error 0 Jumper!! |
Monitoring of the stepping motor movement disabled. |
| Remove the jumper on the left side in the middle of the printed circuit board. | |
| Error 1 |
During the time of high-speed adjustment, a power supply failure, a failure of the output stage or motor locking occurred. Coupling of the motor to the control system has been lost. After switching off/on the power supply a flickering display appear. |
| After removal of the failure, display flickering can be eliminated by performing machine SET-UP, readjusting the diamond position Adj Dia | |
| Error 2 |
The feed motor has run against the limit switch at the end of the ball screw. |
| Retraction from this position can be made by means of the handwheel. | |
| Error 3 |
The feed motor has run against the limit switch at the end of the ball screw. |
| Retraction from this position can be made by means of the handwheel. | |
| Error 4 KS = xx |
Checksum error in EPROM. |
| Replace EPROM marked CNCxxx. | |
| Error 5 |
Range of the axes has been exceeded. |
| Machine SET UP should be effected. | |
| Error 6 Watchdog Alarm |
External function failure detected by diagnostics. |
| Switch off/on the system and check position of axes. | |
| Error 6 Zabloudeni |
External function failure detected by diagnostics, program get lost. |
| Switch off/on the system. | |
| Error 7 XRAM adr. xxxx |
Memory error in RAM |
| On the 2nd line is address of the 1st occurence of error in RAM. | |
| Error 8 |
Parity error detected by diagnostics. |
| Switch off/on the system. | |
| Error 9 CHKSUM SMC... |
Checksum error in SMC EPROM detected by diagnostics. |
| Replace SMC EPROM marked SMC. | |
| Error 9a 1. inic SMC |
Configuration error in Xilinx |
| If the failure recurs a repair is necessary. | |
| Error 9a 2. inic SMC |
Configuration error in Xilinx |
| If the failure recurs a repair is necessary. | |
| Error 42 |
Checksum error 1/2 EPROM. |
| Check all parameters in EPROM and program. | |
| Error 43 |
Checksum error 2/2 EPROM. |
| Check all parameters in EPROM and program. | |
| Error 47 EEPROM addr. xx |
Serial EEPROM 93C46 error on address xx. |
| Replace EEPROM 96C46 |